1

Coffin Treat Box

Pattern A

Pattern B

Pegboards:6 large squares

Other:ScissorsClear tapeClear plastic lacingTreats

Bead Colors:Red - 316Cranapple - 186Orange - 40Plum - 490Purple - 132Dark Grey - 317Black* - 4328Raspberry Pearl Stripe - 190Gold Pearl Stripe - 202Silver Pearl Stripe - 68

Instructions1. The patterns require all 6 boards to be

assembled as shown here. Cut these patterns out and tape together in the same way. If you are using clear pegboards, slide the actual-size pattern underneath them. Place your beads on the pegboards as shown.

2. Ask an adult to fuse your designs—see page 2 for further instructions.

3. Assembly: see page 14.

YOU WILL NEED:

*You will need 5 bags of black beads.

A1

B1

A4

B4

A2

B2

A5

B5

A3

B3

A6

B6

2

Coffin Treat Box

Pattern A1

1. Place your pegboard on a flat, heat-safe surface.

2. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. Do not press down with the iron. As the beads begin to fuse, you will see circles of the beads start to show through the paper. When ironed properly, the beads will still have an open center. Let the design cool.

3. Remove the paper and bead design from the peg board. Flip the design over to expose the non-fused side. Repeat step two. Let cool completely.

NOTE: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Depending on the size of the

project, additional heating time may be required. DO NOT OVER-IRON the beads as it will make the centers of the beads close and can make the assembly you do with your project more challenging.

Fusing Instructions—Only Adults Iron

Lid Locks

Handles

Coffin LidBottom

Coffin Treat Box

3

Pattern A2

Coffin LidBottom

Coffin Treat Box

4

Pattern A3

Coffin LidBottom

Handles

Coffin Treat Box

5

Pattern A4

Coffin LidTop

Coffin Treat Box

6

Pattern A5

Coffin LidTop

Coffin Treat Box

7

Pattern A6

Foot Panel

Head Panel

Coffin Treat Box

8

Pattern B1

Coffin Base

Coffin Treat Box

9

Pattern B2

Coffin Base

Coffin Treat Box

10

Pattern B3

Coffin Base

Short Side Panel

Coffin Treat Box

11

Pattern B4

Short Side Panel

Coffin Treat Box

12

Pattern B5

Long Side Panel

Long Side Panel

Coffin Treat Box

13

Pattern B6

Long Side Panels

Coffin Treat Box

14

ASSEMBLY

1Layer the top and bottom coffin lids together and insert the lid locks through the two pieces.

2Insert the handles into both long side panels facing outward.

Coffin Treat Box

15

3

4

Assemble the coffin by connecting the side piece bottom tabs to the openings in the base. Carefully connect side tabs with side slots. Secure with glue or lacing if desired.

To attach the top of the coffin, thread lacing through the beads indicated in dark pink above on one long side and the lid bottom (3 sections of 6 beads each). Knot at the end of each section to secure.

Headpanel

Short side panel

Long sidepanel

Foot panel

www.eksuccessbrands.comPerler Beads and EKSuccess Brands are either registered trademarks or trademarks of Dimensions Crafts LLC and EK Success Ltd. respectively in the United States and/or other countries. © 2014 Dimensions Crafts LLC. All rights reserved.