403 - Subea Riser Bases
3
Copyright © 08/2008 AME Pty Ltd AME Engineering Excellence Montara Subsea Umbilical Riser Bases Coogee Resources U m b i l i c a l R i s e r B a s e s 3D model of subsea umbilical riser bases. Coogee Resources engaged AME to design two subsea umbilical riser bases for their Montara field develpment project. AME worked closely with Independant Offshore Solutions, to ensure the design met their required installation and operation criteria. The project presented a unique challenge in that the design could only utiilise one specific pre-determined steel member size for all of the primary steelwork, as this was the only member available to the overseas fabricator at the time. By incorporating a combination of permanent and removable external ballast weights, all requirements including those of the fabrication restrictions were met successfully. AME‘s scope of work also included the design and manufacture of the umbilical split clamps and associed riser base interface structures. PROJECT PROFILE Client: Scope: Project Duration: Date: Coogee Resources Design (conceptual and detailed), and fabrication 12 weeks Mar 2008 - Jun 2008
-
Upload
aizat-najib -
Category
Documents
-
view
225 -
download
0
Transcript of 403 - Subea Riser Bases
8/3/2019 403 - Subea Riser Bases
http://slidepdf.com/reader/full/403-subea-riser-bases 1/2
Copyright © 08/2008 AME Pty Ltd AME Engineering Excellence
Montara Subsea Umbilical Riser Bases
Coogee Resources
U m b i l i c a l R i s e
r B a s e s
3D model of subsea
umbilical riser bases.
Coogee Resources engaged AME to design
two subsea umbilical riser bases for their
Montara field develpment project.
AME worked closely with Independant
Offshore Solutions, to ensure the design met
their required installation and operation criteria.
The project presented a unique challenge inthat the design could only utiilise one specific
pre-determined steel member size for all of the
primary steelwork, as this was the only member
available to the overseas fabricator at the time.
By incorporating a combination of permanent
and removable external ballast weights, all
requirements including those of the fabrication
restrictions were met successfully.
AME‘s scope of work also included the design
and manufacture of the umbilical split clampsand associed riser base interface structures.
PROJECT PROFILE
Client:
Scope:
Project Duration:
Date:
Coogee Resources
Design (conceptual
and detailed), and
fabrication
12 weeks
Mar 2008 - Jun 2008
8/3/2019 403 - Subea Riser Bases
http://slidepdf.com/reader/full/403-subea-riser-bases 2/2
AME Pty Ltd
Photos (a-b):
Photos (c-e):
(b)(a)
(d) (e) (f)
(h)
(e)
AME Pty Ltd
Telephone: +61 8 9424 4100
Fax: +61 8 9424 4101Email: [email protected]
Web: www.amepl.com.au
P h o t o g r a p
h s
Copyright © 08/2008 AME Pty Ltd AME Engineering Excellence
Output from Finite Element Analysis(FEA) performed on the split clampand subsea base interface structure.FEA was utilised to ensure the designmet strength and fatigue requirments.
Umbilical split clamp and subsea baseinterface structure undergoing trial
fitup.
(c) (d)
