Post on 05-Jul-2018
8/16/2019 Pesan Error Pada PRTG
http://slidepdf.com/reader/full/pesan-error-pada-prtg 1/2
Pesan Error pada PRTG
1. Error connecting with SSL. EOF was observed that violates the
protocol
Have you checked that it is not a key length issue? New browser and !"#security re$uire%ents en&orce ""' certi(cates be a %ini%u% 1)*+,bit key
in length.
-& you cannot con(gurere$uest the server %eed this %ini%u%/ consider
the &ollowing workaround &or bypassing on the client
side0 http0support.%icroso&t.co%kb*1*2+
3ro% an ad%in co%%and pro%pt/ e4ecute0 certutil ,setreg
chain5%inR"6Pub7ey8it'ength 21*
*. Connection Reset By Peer (10054)
9ause
This generally suggests a network issue which is not related to the VNC a!!lication
itsel"# This could $e due to network hardware $eing either %iscon"igured or "aulty#
Resolution
&s "ar as the a!!lication re!orting the error is concerned' the other end!oint sent a
TCP reset !acket# o%eti%es' $oth end!oints re!ort this error' in which case
so%ething in the %iddle has sent reset !ackets to $oth ends# t*s not !ossi$le "or the
end!oints to get any %ore in"or%ation than this# That un"ortunately %eans the VNC
Viewer cannot tell what has caused the error#
" you wish to trou$leshoot this issue' in+estigating the ,uality o" the connection
$etween +iewer and ser+er is the $est !lace to start# Try sending large !ing !ackets
and do a reasona$ly long !ing test' looking "or any !acket loss# & !ayload o" around
1-50 $ytes is ideal#
.ro% a co%%and !ro%!t/
ping ,t ,l 1:2)
Note: it is a dash lowercase2 a$o+e' not a 1' they look the sa%e in so%e "onts#
3ne co%%on cause o" this error is that the T (a6i%u% Trans%ission nit) si7eo" !ackets tra+elling o+er your network connection ha+e $een changed "ro% the
8/16/2019 Pesan Error Pada PRTG
http://slidepdf.com/reader/full/pesan-error-pada-prtg 2/2
de"ault o" 1500 $ytes# This could ha+e $een con"igured %anually (usually within
router settings)' or could $e due to running VNC o+er a VPN connection#
sing "i6ed P addresses rather than 89CP assigned addresses on your router
settings has $een known to resol+e this issue#