Anypoint Lessons#01 – Hello, World!

Step 01 – Create a new project

Step 02 – Insert the name of your project

Step 03 – This is your empty canvas. Let’s drag a HTTP connector.

Step 04 – This is the connector and your configurations.

Use the configurations as default.

Step 05 – Insert the SET Payload connector. This is where you write your message (“Hello, world!”)

Step 06 – Insert a logger. This way you can monitore your application on the console too.

Step 07 - Run your Project.

Step 08 – Execute your application on your browser. Use the adress of the http connector configuration.

You can see the result on your console too.

See you next time!